Installing the battery cartridge – Printek Mt3-II Series User Manual
Page 10
Getting Started
• The recommended room temperature for charging is between 68°F (20°C) to 77°F (25°C).
• The battery storage temperature is 40°-104°F (4°-40°C). Do not store a fully charged battery at
temperatures greater than 104°F (40°C) for long periods of time – the battery may permanently lose
charge capacity.
• Be sure to use a fully charged battery before long or battery intensive printing sessions. Certain
operations (for example, printing receipts with a lot of bar codes and graphics) drain the battery more
quickly than others.
Caution: Do not disassemble, short circuit, heat above 80°C, or incinerate. The battery may explode.
Battery Disposal
Only dispose of used batteries according to your local regulations. If you do not know your local
regulations, the Rechargeable Battery Recycling Corporation (RBRC) is a non-profit organization
created to promote recycling of rechargeable batteries. For more information visit
Installing the Battery Cartridge
One battery cartridge is included with the printer. Similar to a cordless phone battery, the printer’s battery must
be charged before using it.
Refer to the following picture to install the battery pack in the printer.
1. Unlock the battery door by sliding the battery door release toward the center of the door, and open the
battery door.
4