Printek Mt3-II Series - Manual (Page 17)

Configuration and Data Connectivity
The standard Mt3-II Series printer supports both Serial RS232 and IrDA compatible infrared communication
interfaces.
Serial and IrDA communication settings can be changed via configuration switches located in the paper supply
area (see figure below).
The functions assigned to these switches are shown on the next page.
If the Serial interface is selected, the communication parameters Baud Rate, Data Bit and Parity must be set.
An optional serial cable is available for Serial RS232 communication (part #91251 for DB9 terminated, part
#91252 for unterminated).
Printer drivers for Windows 95/98/NT/2000 and XP are available from Printek.
PrinterCE print control utility is available from Printek for Windows CE and Pocket PC 2002 devices. Demo
software is available from www.fieldsoftware.com. and details on use are available from Printek.
Printboy from Bachmann is recommended for Palm devices. Demo software is available from
www.bachmannsoftware.com. and details on use are available from Printek.
Configuration Switches
Switches 2 & 3 Shown In ON Position
11