Panasonic DMC-LC1GN - Manual (Page 97)

Playback (advanced)
97
Connecting to a PC (Mass Storage)
When you connect to the camera to a PC supporting USB 2.0 (High Speed), you
can transfer the data with higher speed in a shorter period of time.
1 Turn the camera on and then set
[USB MODE] to [Mass Storage].
(P95)
2 Connect the camera to a PC via
the USB connection cable
(supplied).
[Windows]
The drive appears on the
[My Computer] folder.
• If it is the first time for you to
connect the camera to a PC, the
required driver is installed
automatically so that the camera
can be recognized by the Windows
Plug and Play, then it appears on
the [My Computer] folder.
[Macintosh]
The drive is shown on the screen.
¬Suggestions/Tips ¬
• When connecting to a PC, we
recommend using the AC adaptor as
the power source.
• If the remaining battery power
becomes low during communication,
the power indicator blinks and the
alarm beeps. In this case, stop the
communication. Then turn the camera
off and charge the battery.
• When connecting to a PC, pictures
and sounds are not output from the
[AV OUT/REMOTE] socket.
• Use the supplied USB connection
cable only.
• When you connect the camera to a PC
supporting USB 2.0 (High Speed), be
careful of the followings.
• When you connect 2 or more USB
devices to a PC, or you connect the
camera with a USB hub or USB
extension cables, normal operation
is not guaranteed.
• When you connect the camera to
the USB terminal on a key board, it
may not be operated properly.
• Also refer to the operating instructions
of a PC.
AV OUT/
REMOTE
DC IN
USB
ACCESS
LC1-GN.book 97 ページ ２００４年１月２９日 木曜日 午前９時１５分