Precision Power 355cs - Manual (Page 19)

1
crossover connections and input sWitcH settinG
route the wires connected to the input terminals on the crossover network to the
power amplifier . Connect the wires to the amplifier outputs as recommended by
the manufacturer of the unit . Make sure there are no stray strands of wire which
could cause a short circuit . Observe left/right polarity markings .
7ZHHWHU
:RRIHU


&URVVRYHU
,1 287








:RRIHU
7ZHHWHU
:RRIHU
7ZHHWHU




 
6WDQGDUG
6ZLWFKLQ3DUDOOHO3RVLWLRQ
%LDPS 3DUDOOHO
Amplifier
NOTE: In this configuration, you may connect the amplifier (+) positive to either
the tweeter (+) or woofer (+) terminal, and the amplifier (-) negative to either the
tweeter (-) or woofer (-) terminal . The parallel switch ensures that both halves of
the crossover are supplied with signal as least one (+) and (-) input terminal are
connected .