Precision Power 355cs - Manual (Page 5)


cautions
Study your automobile thoroughly before you drill or cut any holes . Take extra care
when working near gas tanks, gas lines, brake or hydraulic lines and electrical
wiring .
Wear eye and ear protection when using power tools . Keep the woofers and
tweeters away from metal filings and shavings . Once foreign objects are stuck to
the magnets or tweeter dome, it will be virtually impossible to remove them . Keep
the tweeters in their protective bags until final mounting to prevent any possibility
of metal dust or chips from passing through the grille and accumulating on the
dome .
Exercise caution when working with the cs series with the grille removed . A slip of
the hand with a screwdriver or other tool can result in irreparable damage to the
cone or dome . Do not touch the cone or dome .
Do not install the components where they will be subject to excessive heat,
moisture or dust, or where they will be kicked or repeatedly bumped or brushed .
Make absolutely sure that the woofer is connected to the lowpass output and the
tweeter is connected to the highpass output of the crossover network . If these
connections are reversed, low-frequency signals will be fed to the tweeter without
fuse protection . In this case, the tweeter may be damaged, such damage is not
covered by the warranty .
When removing or installing the grills be careful not to brush the woofer's rubber
surround or the tweeter's dome with the edge of the grille . Cutting or tearing the
surround or dome will destroy the unit .
Never run wires outside or beneath the vehicle where they can be snagged by
road hazards or the moving parts of the vehicle . Use existing wire channels,
sills, panels and molding strips inside the automobile to hide the wiring for neat
appearance and safety .
Make sure your radio/cassette/cd player and or other equipment is turned off
while connecting the speaker terminals . Turn on the various components and
slowly advance the volume control ONLY after checking and double checking all
connections .
NOTE: If the sound is weak or distorted, immediately turn down the volume and
see the section entitled Troubleshooting .