Panasonic RP WF930 - Manual (Page 10)

10
R
Q
T7
573
Turn on the unit the transmitter is
connected to.
Turn the volume on the sound
source up as much as possible
without causing distortion.
Remove the headphones from the
transmitter.
Reduce the volume of the
headphones with the [VOL] dial.
Switch the [OPR] switch to “ON”.
The OPR indicator goes red.
Put the headphones on.
Adjust the volume on the
headphones.
If there is interference, press the
[TUNING] button to reduce it.
The frequency is adjusted automatically.
See page 12 for more detailed instructions on how
to reduce interference.
After listening
Take the headphones off.
Switch the [OPR] switch to “OFF”.
The OPR indicator goes out.
Reset the headphones on the transmitter, and
recharge them.
Turn off the unit the transmitter is connected to.
•
Avoid listening for prolonged periods of time to prevent
hearing damage.
•
Discontinue use if you experience discomfort with the
headphones that directly contact your skin.
Continued use may cause rashes or other allergic
reactions.
Concerning the AUTO POWER ON/OFF
function:
When audio signals are supplied, the transmitter’s power
is turned on (The OPR/CHG indicator lights in
red.); when audio signals have not been supplied for 2
or 3 minutes, its power is automatically turned off. (The
OPR/CHG indicator goes out.)
When the volume of the connected unit is too low, this
function doesn’t work. Turn up the volume as much as
possible without causing distortion.
4
5
6
7
L
R
3
TUNING
TUNING
OPR / CHG
MAX
VOL
MIN
ON OFF
OPR
ON OFF
OPR
MAX
VOL
MIN
MAX
VOL
MIN
Operation
Note
WF930_EN.fm Page 10 Friday, November 28, 2003 8:13 PM