Python 671XP - Manual (Page 29)

26 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
p po ow we err ssa avve err m mo od de e
Your system will automatically enter Power Saver Mode while
armed or in Valet ® Mode, after a period of time in which no
operation has been performed. This lowers the current draw to
the vehicle’s battery. Power Saver Mode takes over under the
following conditions:
➤ Power Saver when the system is armed: After the system has
been armed for 24 hours, the in-vehicle LED will flash at
half its normal rate, decreasing the system's current draw.
➤ Power Saver in Valet ® Mode: When the system enters Valet ®
Mode the in-vehicle LED illuminates steadily. If the vehicle
is not used (ignition is not turned on) for a period of one
hour while the system is in Valet ® Mode, the LED will shut
off. If the system remains in Valet ® Mode, the LED will
come back on the next time the ignition is turned on and
then back off.
p prro og grra am mm miin ng g o op pttiio on nss
Programming options control what your system does during
normal operation, and require few or no additional parts.
However, some may require additional installation labor.
The following is a list of the program settings, with the factory
settings in B
Boolld d::