Panasonic KX-FC962HK - Manual (Page 18)

3. Preparation
18
3.4 Turning the cordless
handset power ON/OFF
3.4.1 Power ON
Press {ih} for about 1 second.
L The display will change to the standby mode.
3.4.2 Power OFF
Press {ih} for about 2 seconds.
L The display will go blank.
Volume
3.5 Adjusting cordless
handset volume
Ringer volume
1. Press {j/OK}.
2. Select “ Handset Setup”, then press {>}.
3. Select “ Ringer Setup”, then press {>}.
4. Select “ Ringer Volume”, then press {>}.
5. Press {e} or {v} repeatedly to select the
desired volume.
6. Press {>}.
7. Press {ih}.
Note:
L Alarms will sound and the cordless handset
will ring for intercom calls and when paged
even if the ringer is turned OFF.
Ring tone
You can select one of 15 ring tones for outside
calls and intercom calls (page 70). Caller ID
service users can also use a different ringer for
each category (page 35).
Receiver volume
While using {C} or {INT}, press {e} or {v}.
Speaker volume
While using {s}, press {e} or {v}.
{ih}
{ih}
{ INT}
{j /OK}
{C}
{s}
{>}{e}{v}
FC962HK-PFQX2283ZA-en.book Page 18 Thursday, September 15, 2005 4:20 PM