Panasonic KX-FC962HK - Manual (Page 70)

9. Programmable Features
70
9.5.1 Programmable functions
Helpful hints:
L To exit programming, press {ih} at any
time.
9.5.2 Alarm
Setting alarm
An alarm will sound for 3 minutes at the set time
once or daily.
Set the date and time beforehand (page 20).
1. Press {j/OK}.
2. Select “ Handset Setup”, then press {>}.
3. Select “ Time Settings”, then press {>}.
4. Select “ Alarm”, then press {>} 2 times.
5. Select an alarm mode, then press {>}.
– “ Once”: The alarm will sound once at the
set time. Enter the desired day and month
by selecting 2 digits for each.
– “ Daily”: An alarm will sound daily at the
set time.
– “ Off” (default): Turns the alarm OFF.
Press {>} again, then press {ih} to
finish.
6. Enter the desired hour and minute by
selecting 2 digits for each.
L You can select “ AM”, “PM” or 24-hour
time entry by pressing {*} repeatedly.
7. Press {j/OK}.
8. Select the ring tone that will sound at the set
time, then press {>}.
9. Select “ Save”, then press {>}.
10. Press {ih}.
Note:
L To stop the alarm, press any dial key.
L When the cordless handset is in talk or
intercom mode, the alarm will not sound until
the call has ended.
L Alarm volume depends on cordless handset
ringer volume (page 18).
L The alarm will sound at the set time even
when the ringer is turned OFF.
L If you select “ Once”, the setting will be
changed to “ Off” after the alarm sounds.
9.5.3 Ringer options
Changing ring tones
You can choose the ring tone used by the
cordless handset.
“
Ext. Ringtone”: Selects the ring tone for
outside calls.
“
Int. Ringtone”: Selects the ring tone for
intercom calls.
1. Press {j/OK}.
2. Select “ Handset Setup”, then press {>}.
3. Select “ Ringer Setup”, then press {>}.
4. Select the desired item, then press {>}.
5. Select the desired ring tone, then press {>}.
6. Press {ih}.
Note:
L If you select one of the melody ring tones, the
ring tone will continue to sound for several
seconds if the caller hangs up before you
answer. You may hear a dial tone or no one
on the line when you answer a call.
L The preset melodies in this product are used
with permission of © 2004 M-ZoNE Co., Ltd.
L To set the base unit ring tone, see feature #17
on page 62.
9.5.4 Display setup
Selecting the standby mode display
“
Base Number”: The current base unit number
is displayed.
“
Handset Number”: The current cordless
handset number is displayed.
“
Off” (default): Only the current date and time
are displayed.
1. Press {j/OK}.
2. Select “ Handset Setup”, then press {>}.
3. Select “ Display Setup”, then press {>}.
4. Select “ Standby Display”, then press
{>} .
5. Select the desired setting, then press {>}.
6. Press {ih}.
Note:
L If “ Base Number” is selected and the
current base unit number is 2, “ -2-” is
displayed.
{ih}
{j /OK}
{C}
{>}{e}{v}
FC962HK-PFQX2283ZA-en.book Page 70 Thursday, September 15, 2005 4:20 PM