Panasonic KX-MB2030EX - Manual (Page 59)

Feature/Code Selection
Selecting the scale
MBNM1NM4NM7N M1N “MILLIMETRES” (default)
M2N “INCHES”
Note:
R The selected scale will be used when measurements are shown on the
unit’s display.
Changing the password for
feature programming via
remote operation
MBNM1NM5NM5N 1. MMenuN A MBNM1NM5NM5N A MSetN
2. Enter the current password. A MSetN
R The default password is “1234”.
3. Enter a new 4-digit password using 0–9. A MSetN
4. Enter the new password again. A MSetN A MMenuN
Note:
R It is recommended that you change this password from the default
password.
R This password is also used for feature programming via a web browser
(KX-MB2000/KX-MB2010/KX-MB2030, LAN connection only).
Setting the toner
maintenance time
MBNM1NM5NM8N The unit will automatically activate for maintenance, once every 24 hours.
Because this is to prevent the toner from solidifying, the noise that the unit
makes during maintenance cannot be stopped. However, if the unit’s noise
bothers you, you can change the start time.
1. MMenuN A MBNM1NM5NM8N A MSetN
2. Enter the maintenance start time.
R The default time is “12:00”.
R If you selected 12-hour time entry (page 22), press MHN repeatedly to
select AM or PM.
R If you selected 24-hour time entry (page 22), the time is set using 24-hour
time entry.
3. MSetN A MMenuN
Resetting all features (and
deleting all data in memory)
MBNM1NM5NM9N Before you dispose of, transfer or return the product, activate this feature to
reset all programmable features and to delete all data stored in memory.
KX-MB2025/KX-MB2030 only: Phonebook (or caller information) and fax
transmission data (journal report and faxes received in memory) will be deleted.
M0N “NO” (default)
M1N “YES”
R Disconnect the telephone line cord (KX-MB2025/KX-MB2030 only), USB
cable and LAN cable (KX-MB2000/KX-MB2010/KX-MB2030 only) before
activating this feature.
To reset all features:
1. MMenuN A MBNM1NM5NM9N
2. Press M1N to select “YES”. A MSetN
3. Press M1N to select “YES”. A MSetN
Setting the ringer pattern
MBNM1NM6NM1N
(KX-MB2025/KX-MB2030
only) M1N “A” (default)
M2N “B”
M3N “C”
Setting the beep sounds and
keytones
MBNM1NM6NM5N M0N “OFF”: Deactivate this feature.
M1N “ON” (default): You will hear confirmation/error beep sounds and keytones.
Note:
R Even if this feature is set to “OFF”, the unit beeps in the following cases:
– the memory reception alert setting (feature #437 on page 65) is
activated (KX-MB2025/KX-MB2030 only).
– the top cover is opened.
59
8. Programmable Features