Paradyne 3162 - Manual (Page 7)

5
Factory default configuration options are shown in boldface type in the following tables.
Table 1. Network Interface Configuration Options
Option Factory 1 Factory 2 Comments/Description
Line Framing
D4 D4
Selects D4 or ESF framing format
Line Framing
Format:
ESF ESF
Selects D4 or ESF framing format.
Line Coding Format:
AMI AMI
Selects AMI or B8ZS line coding
Line Coding Format:
B8ZS B8ZS
Selects AMI or B8ZS line coding
format.
62411 62411 Provides enforcement of ones
d
it t ti
Bit Stuffing: Part68 Part68
Provides enforcement of ones
density protection per
AT&T TR 62411, ANSI T1-403, and
Bit Stuffing:
Disable Disable
AT&T TR 62411, ANSI T1-403, and
FCC Part 68 Technical Publication.
0.0 0.0
Line Build Out (LBO):
–7.5 –7.5
Provides Line Build Out in dB Line Build Out (LBO):
–15 –15
Provides Line Build Out in dB.
–22.5 –22.5
Management Link:
Enable Enable
Specifies whether the FDL’s
Management Link:
Disable Disable
Specifies whether the FDL s
Management Link is enabled.
ANSI Performance
Enable Enable
Sends ANSI Performance Report ANSI Performance
Report Messages:
Disable Disable
Sends ANSI Performance Report
Messages.
Network Initiated
Enable Enable
Network-initiated LLB allows LLB to Network Initiated
LLB:
Disable Disable
Network-initiated LLB allows LLB to
be controlled by inband LLB codes.
Network Initiated
Enable Enable Network-initiated PLB allows PLB
to be controlled by FDL PLB
Network Initiated
PLB:
Disable Disable
to be controlled by FDL PLB
messages.
Circuit Identifier:
[Text Field] [Text Field]
Specifies the transmission vendor’s Circuit Identifier:
Clear Clear
Specifies the transmission vendor s
circuit identifier.