Peripheral Electronics Aux2Car - Manual (Page 13)

Chrysler (Chrysler, Jeep, Dodge, Plym-
outh, Eagle)
Make sure the Aux2Car adaptor is compatible with your vehicle, Check for “Disc ^” printed on Aux2Car Aux2Car
preset button “1”. If you see it, it means that your radio can control the Aux2Car adaptor. Aux2Car Aux2Car
Before connecting any cables to the Aux2Car you must set the dip switches to the Aux2Car Aux2Car
correct position. If you set the dip-switches after you have connected cables to the
interface, you must disconnect and reconnect them for the Aux2Car to operate. Aux2Car Aux2Car
Remove the radio to see which cable fi ts your vehicle, and then refer to settings below.
Do not force cables in.
DIP SWITCHES MUST BE SET BEFORE YOU PLUG IN THE Aux2Car !!! Aux2Car Aux2Car
VEHICLE INSTALLATION
1 2 3 4 5 6 7 8
on off off on off off off on
SETTINGS FOR
“CHRYSLER OLD
DIN” CABLE
1 2 3 4 5 6 7 8
off off off on off off off on
SETTINGS FOR
“CHRYSLER NEW
DIN” AND “10 PIN
CABLES
Use the PXHCH2 cable with vehicles 1999-2001.
Use the PXHCH3cable with vehicles 2002-2004.
-Connects behind the radio
Use the PXHCH1 cable with vehicles 1995-1999/2000.
-Connects behind the radio
OPERATION FOR
ALL
Switch to the Aux2Car adaptor by pressing the “CD” or Aux2Car Aux2Car
“MODE” button.
11