Peripheral Electronics Aux2Car - Manual (Page 21)

GM Appendix 1
Corvette
Aux2car Adaptor Connection to
Chevrolet Corvette
Most Corvettes are pre-wired to the trunk. In case you can’t fi nd the connector in the
trunk, please do the following:
1. Preparing the GM-A Cable
Take the PXHGM1 cable and cut off the Black and Red plug. You will then have two cables
in your hands. One cable with the big white 22 pin connector and 1 with a small white 9 pin
connector. You will use only the cable with the big White 22 pin connector (connects to the
Aux2Car).
2. Connection to the Vehicle
There are two connectors located behind the radio, one is black and the other is grey. We
will fi rst work with the grey connector.
Grey Connector:
Blue to Connector Brown+White (Pin 11, the 1st pin)
Red to Connector Green+White (Pin 12, the 2nd pin)
Black to Connector Black+White (Pin 13, the 3rd pin)
Yellow to Connector Dark Green (Pin 15, pin 14 is empty)*
Black Connector:
Orange to Black Connector thick Orange (Pin 10, the last pin, +12v)
Brown to Black Connector Black+White (Pin 5, the middle, Ground)
3. Technical Support
If you have any questions or need any support, please feel free to call 800-477-2267 from
9:30am-6pm EST.
NOTE: CORVETTE 2005 IS NOT COMPATIBLE
19