Peripheral Electronics Aux2Car - Manual (Page 7)

VEHICLE INSTALLATION
OPERATION
Once you connect the Aux2Car adaptor, turn on your radio. A CD icon will appear on the Aux2Car Aux2Car
display of your radio showing that the Aux2Car adaptor is ready to use. Aux2Car Aux2Car
Switch to the Aux2Car adaptor by pressing the CD/ Mode button on the radio. Aux2Car Aux2Car
1 2 3 4 5 6 7 8
on off off off off off off on
• All Models (1998-2004) – Pre-wired 13-pin cable in the left-rear
trunk of all Audi vehicles use the PXHAD1
• Audi A8 (2003-2004) – Not Compatible.
• Audi A6 (2004) – Not Compatible.
Audi
Before connecting any cables to the Aux2Car you must set the dip switches to the Aux2Car Aux2Car
correct position. If you set the dip-switches after you have connected cables to the
interface, you must disconnect and reconnect them for the Aux2Car to operate. Aux2Car Aux2Car
Before connecting any cables to the Aux2Car you must set the dip switchs to the Aux2Car Aux2Car
correct position. If you set the dip-switches after you have connected cables to the
interface, you must disconnect and reconnect them for the Aux2Car to operate. Aux2Car Aux2Car
DIP SWITCHES MUST BE SET BEFORE YOU PLUG IN THE Aux2Car !!! Aux2Car Aux2Car
5