Pioneer VSX-C300 - Manual (Page 27)

English
27
En
Fine Tuning Your Surround Sound
10 dB 0 dB
LFE OFF
CENTER speaker distance setting mode
Set the distance from the CENTER speakers to the
listening position.
Follow steps 1-3 on page 25 (if necessary).
Press
% or fi to set the distance of the CEN-
TER speaker from the main listening position
(within a range from 0.3 m to 9.0 m).
Press
# to advance to the next receiver setting mode, or
press
@ to return to a previous receiver setting mode.
Press ENTER if you want to exit the setting
mode.
MEMO:
• The default setting is 1.5 m.
• One step equals about 0.3 m.
• When “
C _” is selected in SPEAKERS setting mode,
the Center distance cannot be set.
• If you do the ROOM SETUP settings after making the
settings here, those will take precedence.
Follow steps 1-3 on page 25 (if necessary).
Press
% or fi to specify the crossover fre-
quency for your small speakers (100 Hz, 150
Hz or 200 Hz).
150Hz 100Hz
200Hz
100 Hz
Sends bass frequencies below 100 Hz to the
subwoofer (or “Large” speakers).
150 Hz
Sends bass frequencies below 150 Hz to the
subwoofer (or “Large” speakers).
200 Hz
Sends bass frequencies below 200 Hz to the
subwoofer (or “Large” speakers).
Press
# to advance to the next receiver setting mode,
or press
@ to return to a previous receiver setting
mode.
Press ENTER if you want to exit the setting
mode.
MEMO:
• The default setting is “
200 Hz ”.
• If there are no “Small” speakers ” in SPEAKERS
setting mode, crossover frequency cannot be set (
−−−
appears in the display).
LFE attenuator setting mode
Dolby Digital and DTS audio sources include ultra-low
bass tones. Set the LFE attenuator as needed to prevent
the ultra-low bass tones from distorting the sound from
all the active speakers.
Follow steps 1-3 on page 25 (if necessary).
Press
% or fi to set the attenuation level:
0 dB : no attenuation
10 dB : LFE volume is reduced
LFE OFF : LFE channel is off.
Press
# to advance to the next receiver setting mode, or
press
@ to return to a previous receiver setting mode.
Press ENTER if you want to exit the setting
mode.
MEMO:
• The default setting is “
0 dB ”.
FRONT speakers distance setting mode
Set the distance from the FRONT speakers to the
listening position.
Follow steps 1-3 on page 25 (if necessary).
Press
% or fi to set the distance of the FRONT
speakers from the main listening position
(within a range from 0.3 m to 9.0 m).
Press
# to advance to the next receiver setting mode, or
press
@ to return to a previous receiver setting mode.
Press ENTER if you want to exit the setting
mode.
MEMO:
• The default setting is 1.8 m.
• One step equals about 0.3 m.
• If you do the ROOM SETUP settings after the settings
here, those will take precedence.