Pioneer VSX-C300 - Manual (Page 39)

39
En
English
Using Other Functions
Resetting the System
Use this feature to reset the system to its factory default
settings.
1 Press the TV/SAT button and the FRONT
button at the same time for five seconds
to return all of the settings to their
default mode.
MEMO:
• If the receiver is disconnected from a power source
for more than a month, or the main power is turned
off, it will reset to the default settings.
• The above reset doesn’t affect the presets that you
have programmed into the remote control (see page
42).
1 1
Analog Input Mode
With this feature you can set the receiver to analog input
mode.
1 1
1 While pressing the DVD button press the
FRONT button. Hold for about one second.
This sets all inputs (DVD, TV/SAT, etc.) to
analog. You will see the following display.
2 Select the input you want to use for your
analog input.
MEMO:
• When you change to another input the mode will be
cancelled.
• The mode is cancelled by turning the receiver off or
doing step 1 again.
B d
DTS MPEG
VIRTUAL
PHONES SURR. STEREO
AUDIO/VIDEO MULTI-CHANNEL RECEIVER VSX-C300
DVD TV/SAT VCR FRONT TUNER MASTER
VOLUME
DOWN UP
DTS MPEG
VIRTUAL
PHONES SURR. STEREO
AUDIO/VIDEO MULTI-CHANNEL RECEIVER VSX-C300
DVD TV/SAT VCR FRONT TUNER MASTER
VOLUME
DOWN UP
Checking your Settings
Use this feature to check your settings on the receiver’s
display. The meaning of the displays for the input signal
are explained below.
1 Press the DISPLAY button on the remote
control.
Each press cycles through the five displays you can
check for information with this function.
These are:
1 The listening mode (see page 30)
2 The tone mode (see page 32)
3 The Midnight listening mode (see page 32)
4 The input signal (see below)
5 Returns to the normal display
MEMO:
• If you don’t press any buttons the receiver returns to
the normal mode after five seconds.
• The listening mode P. SURR refers to Headphones
Surround mode.
VOLUME CHANNEL
DVD
TV/SAT
RECEIVER
REMOTE
SETUP
INPUT
SELECT
INPUT SELECT
MASTER
VOLUME
RECEIVER
TV
TV CONTROL
TUNER FRONT MUTING DISPLAY
VCR
TV
1
The Input Signal Displays Explained
B d
D.D. : Dolby Digital signal
DTS : DTS signal
MPG : MPEG signal
PCM : PCM signal
ANALOG : analog signal
**k : sampling rate (PCM)
**ch : number of channels
DUAL : Dual Mono signal
D.SRD : Dolby Surround signal