Panasonic DMC-TS1 - Manual (Page 20)

VQT1Z45
20
Preparation
∫ About the card/battery door.
If you turn on the power with the card/battery door open, a warning sound will go off in
order to avoid immersion and the message shown below will appear on the LCD monitor.
(P134)
The camera cannot be operated when the card/battery door is open. (Only the ON/OFF
button can be operated) Close it securely so no foreign object is clamped.
•
Messages are not displayed when the terminal cover is opened. Also, the camera can be
operated, but close the cover securely so no foreign object enters before using the camera.
If there is any foreign object, remove it with attached brush.
∫ Connecting the AC adaptor and multi conversion adaptor instead of the battery
Always purchase the AC adaptor (DMW-AC5PP; optional) and the multi conversion
adaptor (DMW-MCA1; optional) as a set. The AC adaptor (DMW-AC5PP; optional) cannot
be used by itself. Also, read the instruction for the multi conversion adaptor (DMW-MCA1;
optional) regarding the connection.
1 Open the terminal cover
2 Connect the camera with the multi conversion adaptor (DMW-MCA1; optional)
• Ensure that only the AC adaptor (DMW-AC5PP; optional) and multi conversion
adaptor (DMW-MCA1; optional) for this camera are used. Using any other equipment
may cause damage.
3 Connect the AC cable to the AC adaptor and a wall outlet.
4 Connect the AC adaptor to the multi conversion adaptor.
Note
• Always use a genuine Panasonic AC adaptor (DMW-AC5PP; optional).
• Always use a genuine Panasonic multi conversion adaptor (DMW-MCA1; optional).
• For information about optional accessories, refer to the “ Digital Camera Accessory System ” .
(P150)
BATTERY COVER OPEN
CHECK THAT NO SAND,
HAIR, OR OTHER OBJECTS
ARE ON THE DOOR SEAL.
VQT1Z45~_eng.book 20 ページ ２００９年１月２８日 水曜日 午後９時３０分