Panasonic DMC-TS1 - Manual (Page 56)

VQT1Z45
56
Advanced (Recording pictures)
[REC] mode:
· ¿
Taking Pictures using Auto Bracket
In this mode, 3 pictures are automatically recorded in the selected exposure
compensation range each time the shutter button is pressed. You can select the picture
with the desired exposure from the 3 pictures with different exposures.
With auto bracket d1 EV
Note
• When setting auto bracket, [ ] appears on the screen.
• When taking pictures using auto bracket after setting the exposure compensation range, the
pictures taken are based on the selected exposure compensation range.
When the exposure is compensated, the exposure compensation value appears on the lower
left of the screen.
• The auto bracket setting is canceled if you turn the camera off or [AUTO POWER OFF] is
activated.
• When auto bracket is set, the auto review function is activated regardless of the auto review
setting. (The picture is not enlarged.) You cannot set the auto review function in the [SETUP]
menu.
• The exposure may not be compensated with auto bracket depending on the brightness of the
subject.
• [Œ] is set for the flash when auto bracket is set.
• Burst is canceled when auto bracket is set.
• Setting of the auto bracket cannot be performed in the following conditions:
– In [TRANSFORM], [PANORAMA ASSIST], [HI-SPEED BURST], [FLASH BURST],
[STARRY SKY], [PIN HOLE] and [FILM GRAIN] in scene mode
– When recording motion pictures
1st picture 2nd picture 3rd picture
d0 EV j1 EV i1 EV
Press 3 [È] until [AUTO BRACKET] appears, set
the compensation range of the exposure with 2/1.
• When you do not use auto bracket, select [OFF] (0).
Press [MENU/SET] to finish.
• You can also press the shutter button halfway to finish.
VQT1Z45~_eng.book 56 ページ ２００９年１月２８日 水曜日 午後９時３０分