Panasonic KX-FM255 - Manual (Page 102)

102
Operations
For Assistance, Call 1-800-435-7329
Using an answering machine
● You paused for over 4 seconds during the conversation. To
resume the conversation, press the
button on the unit. STOP
Cause & Remedy Problem
When I answer a call with the
extension telephone, the unit
switches to the fax mode and
I cannot talk with the other party.
Problem Cause & Remedy
¡ Before installing the Multi-Function Center software, make sure of
the following.
¡ —The facsimile unit is connected to the serial port (COM 1 or 2) of
your PC (see page 80).
¡ —The facsimile unit is turned on.
¡ —There is at least 14 MB of available storage on the hard disk
drive of your PC.
¡ —Windows 3.1, 3.11 or Windows 95 is running.
¡ —All other Windows applications are closed.
¡ —The PC link feature (#14) on the facsimile unit is set to ON (see
page 93).
¡ There is a problem in your gender changer, converter, divider or
switch box. Check their operating instructions.
¡ The cmos setup on the com port you are using is set to OFF. Set to
ON (contact your computer manufacturer or dealer).
¡ The com port is competing with the mouse or network card, or uses
the same IRQ as MFC-Print. Change the IRQ setting (refer to your
Windows user manual).
¡ Your PC has a built-in modem and the device manager may have
assigned the modem to the wrong com port. Change the com port
from built-in modem to MFC (refer to your PC user manual).
¡ The Multi-Function Center software was installed incorrectly. Install
the MFC software by following the operating instructions or label on
the floppy disk.
¡ The disks or disk driver are not normal. Check them using the scan
disk command (refer to your Windows user manual). Or try another
disk to confirm that there is no problem with the disk drive.
¡ You installed the Multi-Function Center software in a compressed
drive. Use other drive or reduce the compression of the
compressed drive.
¡ The device driver switched because another application software
was installed using the same com port as the Multi-Function Center
after installing the Multi-Function Center driver. Reinstall by setting
the com port for the Multi-Function Center to an unused com port.
If you have to use the same com port as the other application
software, change the connection of the driver as follows.
1. Open the Message Center.
2. Select Properties from the File menu.
3. Select the desired port from the PC Connection group.
4. Select the Test button.
¡ The PC link feature (#14) on the facsimile unit is set to OFF. Set to
ON (see page 93).
I cannot install the Multi-Function
Center software.
The Multi-Function Center does not
work.
Multi-Function Center