Pioneer VSX-819H - Manual (Page 23)

Connecting up 03
23
En
English
Français
Deutsch
Nederlands
Italiano
Español
Bare wire connections
A-Speaker terminals:
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
B-Speaker terminals:
1 Twist exposed wire strands together.
2 Push open the tabs and insert exposed
wire.
3 Release the tabs.
Caution
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Make sure that all the bare speaker wire is
twisted together and inserted fully into the
speaker terminal. If any of the bare speaker
wire touches the back panel it may cause
the power to cut off as a safety measure.
Use the PRE OUT outputs to connect
the surround back speakers
Connect the PRE OUT outputs of the unit and
additional amplifier to add a surround back
speaker.
• You can use the additional amplifier on the
surround back channel pre-outs for a
single speaker as well. In this case plug
the amplifier into the left (L (Single))
terminal only.
1 2 3
10 mm
(3/8 in.)
1 2
10 mm
(3/8 in.)
3
COMPONENT VIDEO
ANTENNA
FM
UNBAL
75 Ω
AM
LOOP
Class 2 Wiring
SPEAKERS A
SPEAKERS B
(BD/DVD)
IN 1
(TV/SAT)
IN 2
1 - 2
ASSIGNABLE
OUT
Y P B P R
FRONT
SURROUND
BACK
ZONE2
OUT
MONITOR OUT BD/DVD IN TV/SAT IN
R L
SURRO
R
L (Single) R
PRE OUT
SUBWOOFER
PRE OUT
L R
OUT IN DVR/VCR VIDEO
AUDIO
R L
INPUT
L R
ANALOG
Surround back
channel amplifier
Surround Back speakers
SBL SBR
VSX-819H_KU.book Page 23 Thursday, December 25, 2008 8:36 AM