Princeton Digital (USA) Guitar Effects Console G9.2tt2q - Manual (Page 11)

Switching Modules On and Off With Your Foot During Play (Manual Mode)
ZOOM G9.2tt 20
Foot switch 1
WAH/EFX1 module
Foot switch 3
MOD/EFX2 module
Foot switch 2
PRE-AMP module
Foot switch 4
DELAY module
Foot switch 5
REVERB module
In manual mode, you can use foot switches 1 – 5
to switch the major effect modules on or off. The
module/switch allocation is shown below.
HINT
• When a module is switched on/off, the [STORE/
SWAP] key lights up.
• In manual mode, you can use the knobs on the
panel as in play mode to adjust pre-amp
parameters, patch level, Accelerator, and
Energizer. For details on operation steps, see
"Adjusting the sound" in the section on play
mode (
→ p. 15).
• From manual mode you can switch to edit mode
for editing patches. For details on edit mode,
see page 24.
4. To return to play mode, press the
BANK [
W] foot switch.
NOTE
The changes that you have made to a patch will be
lost when you select another patch. To keep the
changes, store the patch first (
→ p.28).
ZOOM G9.2tt 21
Using the Internal Tuner
(Bypass/Mute Condition)
The G9.2tt incorporates a tuner function that supports regular chromatic tuning as well as special tuning.
This section explains the steps for using the tuner.
Using the chromatic tuner
To use the chromatic tuner function, proceed as
follows.
1. In play mode, manual mode, or edit
mode, press and hold the BANK [
Q]
foot switch.
To use the tuner, the G9.2tt must be set to the
bypass condition (effects off) or mute condition
(original sound and effect sound both off).
● To switch to the bypass condition
Hold the BANK [ Q] foot switch for about 1
second, until the indication "BYPASS" appears
on the display. Then release the foot switch.
The G9.2tt is now in the bypass condition.
HINT
You can switch to the bypass condition by
pressing the [BYPASS/TUNER] key.
● To switch to the mute condition
Hold the BANK [ Q] foot switch until the
indication "BYPASS" changes to "MUTE".
Then release the foot switch. The G9.2tt is now
in the mute condition.
After "BYPASS" or "MUTE" was shown, the
display automatically switches to the tuning
display.
NOTE
You can switch to the mute condition by pressing
and holding the [BYPASS/TUNER] key.
HINT
• The built-in expression pedals function as
volume pedals in the bypass condition (in the
mute condition, the pedals have no effect).
• By turning the parameter knob 2, you can select
other tuner types besides the chromatic tuner.
For more information, see the next section.
• The number shown in reverse on the display
indicates that the corresponding parameter
knob can be used for adjustment.
2. Play the open string to tune.
The [GROUP/BANK] indicator shows the note
which is closest to the current pitch.
BYPASS BYPASS
Release switch when
"BYPASS" is shown
Release switch when "MUTE"
is shown
MUTE MUTE
Tuner type Reference pitch
> >˙<
™CHROMATC CHROMATC £440Hz 440Hz