Panduit DPOE PN380C - Manual (Page 2)

DP O E™ Power System User Manual Part Number: PN380C
ii
SAFETY WARNING
The DP O E™ Power Patch Panel Power System is for use in restricted access locations only. It is suitable
for mounting on concrete or other non-combustible surfaces.
Always observe standard safety precautions during installation, operation and maintenance of this
product. Read the installation instructions before performing any work. Only a competent technician who
is aware of the hazards involved should carry out adjustment, maintenance or repairs. Do not work on the
system or connect or disconnect cables during periods of lightning activity. Ultimate disposal of this
product should be handled according to all national laws and regulations.
WARNING: HAZARDOUS VOLTAGE AND ENERGY LEVELS ARE PRESENT THAT CAN
PRODUCE SERIOUS SHOCKS AND BURNS. Only authorized, qualified, and
trained personnel should attempt to work on this equipment.
CAUTION: The plug end of the cords used to connect to the Alternating Current (AC) source
are considered to be the primary disconnect means, and reasonable access must
be given to the plug and receptacle area. The receptacle must be fed with a
breaker or fuse according to the instructions in this guide.
CAUTION: ALL RECTIFIERS EMPLOY INTERNAL DOUBLE POLE/NEUTRAL FUSING.
FCC Compliance Statement
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for the compliance could void the user's authority to operate this
equipment.
WARRANTY
Unless otherwise specified, all products presented in this user's guide are warranted against defects in
material and workmanship for a period of one year from the date of invoice by PANDUIT® Corp. to the
initial purchaser. During the warranty period PANDUIT Corp. will, at its discretion, either repair or replace
products that prove to be defective. For warranty service or repair, the product claimed to be defective
must be returned to a service facility designated by PANDUIT Corp. Buyer shall prepay all the shipping
charges to PANDUIT Corp. and if, in the opinion of PANDUIT Corp., the product is defective, PANDUIT
Corp. shall pay shipping charges to return the product to Buyer. However, Buyer shall pay all shipping
charges, duties and taxes for products returned to PANDUIT Corp. from another country. PANDUIT Corp.
warrants that its firmware designed by PANDUIT Corp. for use with an instrument will execute its
functions when properly installed on that instrument. PANDUIT Corp. does not warrant that the operation
of the instrument or the firmware will be uninterrupted or error-free.
The foregoing warranty shall not apply to defects resulting from improper or inadequate maintenance by
Buyer (buyer-supplied firmware or interfacing unauthorized modification or misuse, operation outside of
the environmental specifications for the product, or improper site preparation or maintenance). No other
warranty is expressed or implied. PANDUIT Corp. specifically disclaims the implied warranties of
merchantability and fitness for a particular purpose.