Pioneer PureVision PDP 42A3HD - Manual (Page 16)

05 Preparation
16
En
Cautions regarding the remote control unit
• Do not expose the remote control unit to shock, liquid, or
high humidity.
• Do not place the remote control unit under direct sunlight;
the unit may deform.
• The remote control unit may not work properly if the remote
sensor window of the Plasma Display is under direct sunlight
or strong lighting. In such case, change the angle of the
lighting or Plasma Display, or operate the remote control unit
closer to the remote sensor window.
• When any obstacle exists between the remote control unit
and the remote control sensor, the remote control unit may
not function.
• As the batteries become empty, the remote control unit can
function within a shorter distance from the remote control
sensor. Replace the batteries with new ones if necessary.
• The Plasma Display emits very weak infrared rays from its
screen. If you place such equipment operated through
infrared remote control as a VCR nearby, that equipment may
not receive commands from its remote control unit properly
or entirely. If this is the case, place that equipment at a
location far enough from the Plasma Display.
• Depending on the installation environment, infrared rays
from the Plasma Display may not allow this system to
properly receive commands from the remote control unit or
may shorten allowable distances between the remote control
unit and the remote control sensor. The strength of infrared
rays emitted from the screen differs, depending on images
displayed on the screen.
Cable connections for watching digital
and/or conventional TV channels
This system is equipped with two terminals for inputting TV
broadcasting signals: ANTENNA/CABLE IN and DTV-ANTENNA
IN. The ANTENNA/CABLE IN terminal accepts conventional TV
broadcasting signals. The DTV-ANTENNA IN terminal accepts
digital TV broadcasting signals. When using a cable TV to
watch conventional TV channels, connect to the ANTENNA/
CABLE IN terminal as shown.
Connecting to an Aerial
To view TV channels correctly, the Plasma Display must receive
a signal.
Connecting the aerial of digital TV
When you connect the aerial of digital TV, connect the outdoor
aerial.
DTV-
ANTENNA IN
Connecting the aerial of analog TV
There are three ways to connect the aerial or network input
cable for analog TV.
It is recommended to connect the outdoor aerial for the best
outcome of the images.
Cable
Converter
ANTENNA
/ CABLE IN
Cable TV
06-PDP42A3HD-Eng (14-17) 5/17/05, 7:29 PM 16