Paradyne 8784 - Manual (Page 33)

3. Initial Startup and Configuration
8784-A2-GB20-30 February 2001 3-9
5. Position the cursor at the Start Transfer field. Use the spacebar to select Yes.
Press Enter.
When the data transfer is complete:
— If you selected Yes in Step 4, the unit is reset.
— If you selected No, the Transfer Status field changes to Completed
successfully .
If you specified No (the default) in the Immediately Apply Download field in
Step 4, you must now apply the download.
Procedure
To apply the downloaded firmware:
1. Press the Escape key to return to the Control menu. Select Apply Download.
2. On the Apply Download screen, type Yes to reset the card and activate the
code.
Selecting Yes causes the termination unit to reset.
NOTE:
The termination unit has two flash memory banks to hold executable firmware.
You can switch between these two firmware versions by applying the firmware
listed on the Apply Download screen.
main/control/apply_download Hotwire
Slot: 4 Model: 8784
APPLY DOWNLOAD
Switch To Code Revision A01.00.02: No
WARNING:
An answer of “yes” will cause the system
to reset as if it had been powered off and on!
-------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu MainMenu Exit
Select: Yes, No LOS at Net, Pt 1