Panasonic C9700U - Manual (Page 7)

24
CQ-C9800/9700U CQ-C9800/9700U
25
General
(continued)
Open the Front Panel
Press [ <: eject] (OPEN).
Note:
≥ If nothing is changed for 20 seconds, the original
panel position will be recovered.
Close the Front Panel
Press [ <: eject] (OPEN) again.
[MENU] (DIM) [ <: eject]
(OPEN/TILT)
Panel Angle (Tilt)
Press and hold [ <: eject] (TILT) until you hear a
beep (about 1 second) from the speaker output, and
“TILT” is displayed. And then release it.
Set it to the position at which it is easy to read what
is on the display.
Each time the above operation is repeated, the panel
angle changes in the sequence shown below.
Dimmer
Press and hold [MENU] (DIM) for more than
2 seconds to change dimmer level setting as
follows.
Brighter (default)
Medium
Darker
[SQ] (Sound Quality)
Note:
≥ The position which has been set using TILT will
be retained even when the operations below are
performed.
• OPEN/CLOSE • ACC on/off
E
N
G
L
I
S
H
6
E
N
G
L
I
S
H
5
TILT 1
TILT 2
TILT 3
Open
TILT OFF
(default)
SQ (Sound Quality)
You have 6 preset modes (FLAT, POP, ROCK,
VOCAL, JAZZ, CLUB). You can customize your
settings for these (except FLAT) and save them for
instant recall.
SQ9 (9-Band Sound Quality)
Center frequency and level are adjustable in each of
9 bands. This lets you fi ne tune sound quality for
each genre to suit car-interior acoustics and your
personal preferences (page 46).
Press [SQ] to select a sound types as follows.
SQ9 lights (except FLAT).
Flat frequency response
not emphasize. (default)
Prevention of excessive
equalizing and capability
to cover wide variety of
music. Listener-friendly
and crisp sound.
Sharp and dynamic
sound. Powerful deep
bass and turgescent
treble.
Highlighted vocals
that are apt to be
overwhelmed by
instrumental sound.
Sound with emphasis on
sharpness of high-hat
and echo of saxophone.
Jazz-specifi c deep
sound.
Reproduction of realism
being in a club.
FLAT
ROCK
POP
VOCAL
JAZZ
CLUB
≥ If [<: eject] (OPEN) is pressed when a
disc is in the player, the front panel opens
and the disc is ejected automatically.
If no operation takes place for 20 seconds, the
disc is automatically retracted into the main unit.
Press [DISP] (display) to return to the regular
mode.
Note:
≥ If no operation takes place for more than
5 seconds, the display returns to the regular mode.
≥ Do not activate SQ and DC (bass/treble) at the
same time to avoid causing sound distortion.
≥ After pressing [SQ] on the main unit, you
can also select a sound type by pressing
the preset buttons [1] to [6].
Display Change
Press [DISP] (display).
∫ When Power is ON
Mode display
Folder hierarchy display
(MP3/WMA only)
Mode and Moving
picture display/
SA display (page 51)
Moving picture/
SA display (page 51)
Mode and Still picture
display
Still picture display
Mode and clock display
Display and light off
Clock display
Display and light off
∫ When Power is OFF
Note:
Displays before adjusting the clock (page 11).
≥ Set the background display (GRAPHIC PATTERN,
STILL IMAGE) in a separate procedure (page 54).
≥ “––:––” will appear before adjusting the clock on
the right corner of the mode display.
[DISP]
(Display)
Caution:
≥ Keep your fi ngers and hands away from the
front panel when the panel is in motion.