Planet Technology ADW-4300A - Manual (Page 13)

Installation
7
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the ADSL
Wireless Firewall Router. Both 10Base-T and 100Base-TX connections can be
used simultaneously.
If required, connect any port to a normal port on another Hub, using a standard
LAN cable. Any LAN port on the ADSL Wireless Firewall Router will automatically
function as an "Uplink" port when required.
3. Connect ADSL Cable
Connect the supplied ADSL cable from to the WAN port on the ADSL Wireless
Firewall Router (the RJ11 connector) to the ADSL terminator provided by your
phone company.
4. Power Up
Connect the supplied power adapter to the ADSL Wireless Firewall Router and
power up.
Use only the power adapter provided. Using a different one may cause hardware
damage
5. Check the LEDs
•
The PWR LED should be ON.
•
The STATUS LED should flash, then turn Off. If it stays on or blinking after 60
seconds, there is a hardware error.
•
For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the
PC is also ON.)
•
The WLAN LED should be ON
•
The ADSL LED should be ON if ADSL line is connected.
For more information, refer to Front-mounted LEDs in Chapter 1.