Pioneer PDP-428XG - Manual (Page 17)

Preparation 05
17
En
Eng
lis
h
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the plasma television.
Note
• If the antenna is not connected correctly, the quality of
reception may be impaired. If images are not displaying
correctly, check whether the antenna connection is correct or
not.
Routing cables
Use the speed clamps as necessary to route the connecting
cables. The diagrams below show the location of the holes on the
rear of the display.
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the plasma
television and snap [2] into the back of [1] to lock the clamp.
• Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
• Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
• Be careful not to subject any connecting cables to strain.
Note
• Use the speed clamps as necessary.
Tidying the speaker cables (PDP-508XG only)
Use the supplied bead bands as necessary to tidy the speaker cables.
Attaching the ferrite core
(when a ferrite core is not attached)
To help prevent noise, attach the supplied ferrite core to the
connector end of the power cord as shown. Use the supplied cable
tie to prevent the ferrite core from slipping on the cable.
Connecting the power cord
Note
• Disconnect the power cord from the power outlet when the
plasma television is not going to be used for a long period of time.
• After all other components are connected, connect the power
plug to the AC outlet.
MONITOR OUT SUB WOOFER
PDP-508XG (Rear view)
MONITOR OUT SUB WOOFER
PDP-428XG (Rear view)
MONITOR OUT SUB WOOFER
PDP-428XG (Rear view)
1
2
MONITOR OUT SUB WOOFER
Speaker cable
Bead band
Rear view
Ferrite core
Cable tie
AC power cord
To power outlet
As close as possible
1
2 3
4
MONITOR OUT SUB WOOFER
To power outlet
Power cord
Rear view
Ferrite core
Partially eliminates noise
caused by the power source.