Pioneer PDP-428XG - Manual (Page 22)

Watching TV 06
22
En
1 Press c to select the display mode.
Each time you press c, the display mode is switched between
2-screen, picture-in-picture, and single-screen modes.
• In 2-screen or picture-in-picture mode, press to switch the
position of the two screens shown.
• The left screen (in the 2-screen mode) or the larger screen (in
the picture-in-picture mode) is the active screen, indicated by a
“
z” icon. You can use any of the normal functions to change
the picture and sound.
• In picture-in-picture mode, press to move the position of
the small screen anti-clockwise.
2 To select the desired input source, press the appropriate
input source button.
• If watching TV programs, press P+/P– to change the channel.
Note
• The multiscreen function cannot display images from the same
input source at the same time. If you make such an attempt, a
warning message appears.
• The multiscreen function cannot display images from
combinations of two external input sources (“INPUT 1” to
“INPUT 6”, “PC”). It can display images from the following
combinations of inputs sources: built-in TV tuner and one
external source (“INPUT 1” to “INPUT 6”, “PC”).
• When you press HOME MENU, the single-screen mode is
restored and the corresponding menu is displayed.
• When in the 2-screen mode, images displayed on the right
screen may look less fine, depending on images.
• With headphones connected, you can listen to audio coming
from the sub screen when in the 2-screen or picture-in-picture
mode. For more information, see Listening to audio from the
sub screen using headphones on page 33.
Freezing images
Use the following procedure to capture and freeze one frame from
a moving image that you are watching.
• Before operating with the remote control unit, make sure to
select the TV mode using its SELECT button. See Controlling
other equipment using the supplied remote control unit on
page 50.
Important
• Displaying a static image for a long period of time, or for
shorter periods of time everyday, may result in image retention.
• Press d.
A still image appears on the right screen while a moving image is
shown on the left screen.
• Press d again to cancel the function.
Note
• You cannot freeze the picture when using the 2-screen or
picture-in-picture mode.
• When this function is not available, a warning message
appears.
Normal image Still image