Pioneer PDP-428XG - Manual (Page 20)

Watching TV 06
20
En
Note
• You can select “Auto”, “High”, “Mid” or “Low” for the brightness
of the POWER ON indicator. When “Auto” is selected, the
brightness of the indicator changes to “High”, “Mid” or “Low”
to match the brightness level of the viewing area. For details,
see Blue LED Dimmer on page 39.
Changing channels
Use the remote control or the control panel on the right-hand side
of the plasma television to change channels.
• Before operating with the remote control unit, make sure to
select the TV mode using its SELECT button. See Controlling
other equipment using the supplied remote control unit on
page 50.
Using P+ / P– on the remote control unit
• Press P+ to increase the channel number.
• Press P– to decrease the channel number.
Note
• CHANNEL +/– on the plasma television operates the same as
P+/P–.
• Press CH RETURN to switch back to the previous channel.
Press again to return to the current channel.
• P+/P– cannot pick up channels that are set to skip. For Channel
Skip, see steps 13 and 14 under Setting up TV channels
manually on page 25.
Using 0 to 9 on the remote control unit
• Select channels directly by pressing buttons 0 to 9.
For example:
Press
2 to select channel 2 (one-digit channel).
Press 1 then 2 to select channel 12 (two-digit channel).
Press 1, 2 then 3 to select channel 123 (three-digit channel).
When viewing Teletext information:
• View a page directly which is three-digit page number from 100
to 899 by pressing buttons 0 to 9. See also Operating the
Teletext basics on page 61.
Note
• Press CH RETURN to switch back to the previous channel.
Press again to return to the current channel.
• After entering a channel number you can press
CH ENTER to tune in the channel more quickly.
• In standby, when you press 0, the power turns on and images
come from the “INPUT 1” source. Or, when you press any
button from
1 to 9, TV images display.
Changing the volume and sound
Use the remote control or the control panel on the right-hand side
of the plasma television to adjust the volume.
Using i + /i – on the remote control unit
• Press i + to increase the volume.
• Press i – to decrease the volume.
• VOLUME +/– on the plasma television operates the same as
i + /i –.
Using e on the remote control unit
• Press e to mute the sound.
e appears on the screen.
• Press e again or i + to restore the sound.
8
AAA
STEREO
STANDARD
FULL
Channel display
Volume adjustment
Muting