Proxima ASA 7911 - Manual (Page 28)

22
To reset the unit back to the default setting, manually set the
Destination Address to 0.0.0.0 or reset the unit to factory de-
faults from within the software configuration menu.
When using this feature, have only two Serial Adapters config-
ured to Domain 8 on the rotary switch at any point in time. If
only one unit is configured for Domain 8, the Pairing Domain
will not change the unit’s configuration. If three Serial Adapters
are set to Domain 8 and then powered on, the outcome will be
unpredictable and may not result in a successful pairing of two
of the units.
The Pairing Domain feature is only available when the Domain
Switch is in use. This feature is not operational when a Serial
Adapter has been configured to Domain 8 from within the
software configuration menu or when the Domain Switch setting
has been overridden by the software configuration menu.
LED Indicators
There are three LEDs on the top panel of the RangeLAN2 791x
Serial Adapter:
❑ The Status LED on the right side (with the unit orien-
tated so that you can read the Proxim logo), changes
colors from yellow (initializing) to green (operational).
This LED blinks red in a repeating pattern when a
problem occurs with the unit. See Chapter 14 for a
further discussion of these patterns.
❑ The Radio LED in the center blinks yellow when the
Serial Adapter is transmitting data packets over its
radio.