Proxima ASA 7911 - Manual (Page 54)

48
cate with the wired infrastructure, it will be necessary to change
the default address to one which is on the same subnet as the
wired stations so that IP packets are routed correctly. You can
override the default address using the IP Address option in the
configuration menu. This parameter will not change unit the
Serial Adapter is reset.
Subnet Mask indicates the mask that will be used to determine
on which network the RangeLAN2 Serial Adapter is located.
Local Port Number signifies the port number on which the unit
will receive packets from another Serial Adapter. The default
port number is 5000. Do not change this parameter unless you
experience a port number conflict in your application.
Remote Port Number signifies the port number on which the
unit will send packets to another Serial Adapter. The default
port number is 5000. Do not change this parameter unless you
experience a port number conflict in your application.
If a packet is destined for an IP host or node that belongs to a
different IP subnet, the RangeLAN2 Serial Adapter will send IP
packets to the Default Gateway Address (usually a router) for
the packets to be routed to the proper destination. This param-
eter will not change until the Serial Adapter is reset.
Note:
If a pair of Serial Adapters are communicating with one
another across a router, you must manually assign each
unit a valid IP address within its subnet and set the
Default Gateway Address and appropriate Destination
Address. You may not use the Pairing Domain feature
to assign Destination Addresses in this scenario.