Proxima ASA 7911 - Manual (Page 13)

7
4. Each RangeLAN2 791x Serial Adapter is preconfigured
to use Domain 0. If you have multiple pairs of Serial
Adapters and each pair consists of one Master and one
Station, set each pair to a unique Domain number.
Using the Domain rotary switch on the underside of the
RangeLAN2 Serial Adapter, set each pair to a unique
Domain number from 0-8 to ensure minimal interfer-
ence. If you decide to use Domain 8, refer to Chapter 5
for information concerning this switch setting’s role in
the Pairing Domain communication feature.
Note:
Do not set the Serial Adapter to use Domain 9 on the
Domain rotary switch. Setting the Domain rotary
switch to 9 will send the Serial Adapter into a configu-
ration mode, and the unit will not be operational.
5. Plug the power supply into the RangeLAN2 Serial
Adapter DC power jack, located on the rear panel, and
plug the power supply into an AC outlet. Upon com-
pleting this step, the LED indicator on the top panel of
the unit will glow yellow and then turn green, indicating
that the unit is ready for operation.
6. Your RangeLAN2 Serial Adapters are now ready for
use with your desired application. However, if your
RangeLAN2 Serial Adapters fail to communicate or fail
to exchange information, you may need to compare
your application’s settings with the RangeLAN2 Serial
Adapter’s default values. Please consult Chapter 6 for
information on how to customize your RangeLAN2
Serial Adapter configuration and Chapter 14 for trouble-
shooting suggestions.