Proxima ASA 7911 - Manual (Page 87)

81
MCP Responses From Serial Adapter
This section describes the format of MCP response messages
passed from the Serial Adapter to an External Computer.
Data Packet Received
Purpose: This is the message used by the Serial Adapter to deliver
packets to the External Computer which have been received by
the Serial Adapter over the radio.
Message Format:
BYTE response (ASCII ‘d’, 64H)
BYTE rssi ;Radio signal strength of received
:packet
BYTE pinstat ;RS-232 pin status of sending node
BYTE len H ;Length of the user message
BYTE len L
BYTE srcaddr H ;IP Address of source
BYTE srcaddr 3
BYTE srcaddr 2
BYTE srcaddr L
BYTES user message
Status Indication of Transmitted Packet
Purpose: This message informs the External Computer of the
status of the most recent data message sent to the Serial Adapter
with the Transmit Data Packet command. The response contains a
duplicate of the sequence number provided in the original Trans-
mit Data Packet message, as well as the length and destination
address. In addition, a StatusInd code is provided which indi-
cates whether the message was sent successfully to the TCP/IP
stack or not.