Parasound AVC-2500 - Manual (Page 48)

48
To Erase All the Programmed Commands within a Page
1. Press and hold the device button and Mem/Enter buttons simultaneously until the amber
status LED and the device button turns on and remains lit.
2. Press and hold the Light button for five seconds. The status LED will flash red five
times, flash green twice and return to steady amber.
3. To exit, press and hold the device button and the Mem/Enter buttons simultaneously,
again. The amber status LED flashes twice and turns off and returns to normal.
To Erase All the Learned Commands in all Pages
Caution: This procedure permanently erased all commands programmed into the remote and
restores default codes.
1. Press and hold the TV Device button and the Light button simultaneously for 10 seconds.
The red Status LED will flash continuously. The status LED wills then flash green then,
amber, then turn off to indicate that all of the learned commands on the remote control
have been erased.
Programming Macros into the Learning Remote Control
Each of the five macro buttons (On-Off, MAC 1, MAC 2, MAC 3, and MAC 4) can transmit
up to 10 commands with one press of a button. Macro buttons can be used to facilitate one
touch operation of your home theater system. For example, you can program the MAC 1
button to turn on the AVC-2500 and all of your other source components then issue a play
code for your DVD player.
The five macro buttons operate independently in two groups of device buttons on the remote
control. The first group consists of the upper row of device buttons (AVC, CD, DVD, AUX)
The second group consists of the lower row of device buttons (SAT, TV, VCR, CBL).
Program the Macro buttons for the upper group with the AVC device button. Once
programmed, you can activate any of these macro buttons while in any of the upper row of
device pages (AVC, DVD, CD, AUX). However, you cannot activate macros programmed in
the upper row while any of the lower pages are activated.
Program the Macro buttons for the lower group with the SAT device button. Once programmed,
you can activate any of these macro buttons while in any of the lower row of device pages
(SAT, TV, VCR, CBL). However, you cannot activate macros programmed in the lower row
while any of the upper pages are activated.
Programming Macro Buttons
1. Press and hold the upper or lower row device button (AVC or SAT) and the THX button
simultaneously until the red status LED and the device button both remain lit.
2. Press the macro button you wish to program. (On-Off, MAC 1, MAC 2, MAC 3, or MAC 4)
3. Select and press up to 10 buttons for commands you want to store in the macro. Pressing
a device button to change device modes is counted as one command.
4. Press the Digital
̅ ̅ ̅ ̅ ̅ or ̃ ̃ ̃ ̃ ̃ buttons to save the selection. The red status LED and the
device Button will blink twice to confirm the programming and then turn off.
5. To add a Power (On/Off) command to the macro during programming you must press
the THX button in the desired Device mode first.
6. Since the Digital
̅ ̅ ̅ ̅ ̅ or ̃ ̃ ̃ ̃ ̃ buttons are used in the programming sequence, these buttons
cannot be used in a macro.
Erasing Macros
1. Press and hold the AVC or SAT device button and THX buttons simultaneously until the
red status LED and the device button turn on and remain lit.
2. Press the macro button to be erased on the universal remote control.
4. Press the Digital
s or t buttons. The red status and device LEDs will flash twice and
turn off.