Pelco VBP3000 - Manual (Page 11)

3. Remove the additional monitorand pouch from the front compartment of the bag, making
sure to feed the bottom piece of the pouch into the long slot of the monitor and attach the
Velcro strap to fasten the monitor in the pouch. Then loop the strap of the pouch around
the headrest of the same row, and pull the end of the strap when holding the buckle until
the pouch is tightly secured.
4. Insert one end of the DIN cable into the MONITOR PORT on the side of the detached monitor.
Slide the cable through the slot in the bag and insert the other end into the MONITOR PORT
on rear of the main unit. For an additional monitor, repeat this process using second of the
two DIN cables supplied with the unit.
J. Using the System in a Hotel, Office or Home (Refer to Figure 12.)
Figure 12
1. Place the unit on a table or other level surface with the unit bottom facing down. Adjust
the screen for a desired viewing angle. This can be done with or without the unit inside
its bag.
2. Take the second monitor from the front compartment of the units bag. rotate the base of
the monitor backward so that it may be placed on a table or other level surface. Adjust
the screen for a proper viewing angle. This can be done with or without the monitor
inside its bag of its pouch.
3. Insert one end of the DIN cable into the MONITOR PORT on the side of the detached
monitor. Slide the cable through the slot in the bag and insert the other end into the
MONITOR PORT on rear of the main unit.
11