Pelco VBP3000 User Manual
Page 6
Note:
1). When the monitor is connected to the main unit the unit will supply inside power to the
monitor, there is no need for another power source to be connected to the DC 12V IN
jack on the side of the monitor.
2). Refer to Figure 5 and 6. When the monitor is separated (either the monitor detached from
the main unit or the additional monitor), You can connect the MONITOR PORT on the
side of the monitor to the MONITOR PORT on the rear of the main unit with the supplied
DIN cable. If in the vehicle, insert one end of the DIN cable into the MONITOR PORT on
the side of the detached monitor, slide the cable through the slot in the bag and insert
the other end into the MONITOR PORT on rear of the main unit. After plugging in the main
unit, DC 12V power, Audio/Video and IR signals will all be supplied through DIN cable
to the separated monitor.
Figure 5
Figure 6
3
3
3
3
3
3
3
3
3
3
6