Pelco VBP3000 - Manual (Page 9)

Option 3 (Refer to Figure 9)
Figure 9
1. Follow the installation instructions shown in the Option 1.
2. Remove the additional monitor and pouch from the front compartment of the bag, make
sure to feed the bottom piece of the pouch into the long slot of the Monitor and attach the
Velcro strap to fasten the monitor in the pouch. Then loop the strap of the pouch around
the headrest and pull the end of the strap while holding the buckle until the pouch is tightly
secured.
3. Insert one end of the DIN cable into the MONITOR PORT on the left right side of the
detached monitor, slide the cable through the slot in the bag and insert the other end into
the MONITOR PORT on rear of the main unit.
9