Planet Technology G.SHDSL Bridge/Router GRT-402 - Manual (Page 12)

PLANET Technology Corp. GRT-101/401/402 User’s Manual
2.4 Setting up the hardware environment
Step 1: Connect the power adapter to the port labeled DC-IN on the rear
panel of the product.
Step 2: Connect the Ethernet cable.
If GRT-101 is directly connected to PC, the Ethernet cable has to be
used cross over one (refer to figure 2-6). If the product is connected
to hub or switch, be sure that the hub or switch supporting
auto-MDI/MDI-X or not. If yes, both crossover and non-crossover
Ethernet cable are suitable. If not, only non-crossover Ethernet cable
could be used (refer to figure 2-7). Since GRT-401 and GRT-402’s
LAN port supports auto-MDI/MDI-X, both crossover and
non-crossover Ethernet cable are suitable.
Step 3: Connect the phone cable to the product. Connect the other side of
phone cable to wall jack.
Step 4: Connect male end of RS-232 cable to the product and female end to
any free COM port in PC.
Step 5: Connect the power adapter by plugging power supply.
- - 7