Planet Technology G.SHDSL Bridge/Router GRT-402 - Manual (Page 13)

PLANET Technology Corp. GRT-101/401/402 User’s Manual
Chapter 3 Configuration
3.1 Purpose
This chapter provides information about configuring GRT series.
Note: After you have completed all necessary setting for GRT series, make sure to write the new configuration to
NVRAM by “write” command and reboot the system, or all of your changes will not take effect.
3.2 Logon Procedure
There are three methods to logon to GRT series: serial console, Telnet, and
web interface. For the first time configuration, perhaps only the serial console
mode could be used because applications requiring Internet protocol (IP)
communication, such as Telnet and web interface, are not available unless a
management IP is configured properly for your local networking environment.
After connecting all the necessary cables described in Chapter 2 Installation,
power on GRT series and select one of the following procedures to access
GRT series.
Note: It is recommended that only one configuration application is used to setup GRT series at any given time, that is,
Telnet, serial console and the web management interfaces should not be used simultaneously.
3.2.1 Serial console
Check the connectivity of the RS-232 cable from your computer to the serial
port of GRT series. Start your terminal access program with VT100 terminal
emulation. Configure the serial link with baudrate of 9600, 8 data bits, no parity
check, 1 stop bit, and no flow-control, and press the SPACE key until the login
screen appears. When you see the login screen, you can logon to GRT series.
User: admin
Password: *****
Note: If you have not set any user profile for GRT series, enter the factory default user “admin”. When the system
prompts you for a password, type “admin” to enter GRT series.
After you logon to GRT series and before proceeding any further, check the
software version of GRT series by the command:
- - 8