Panasonic KX-TG1850NZ - Manual (Page 21)

Handset Settings
21
several seconds if the caller hangs up
before you answer. You may hear a dial
tone or no one on the line when you
answer a call.
L
The preset melodies in this product are
used with permission of © 2004 M-ZoNE
Co., Ltd.
Night mode
Night mode allows you to select a block of
time during which the handset will not ring
for outside calls. This feature is useful for
times when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set independently for the handset and the
base unit (page 26).
Using the phonebook’s category feature
(page 16), you can also select categories of
callers whose calls will override night mode
and ring the handset (Caller ID subscribers
only).
Set the date and time beforehand (page 12).
Setting the start and end time for night
mode
1 Press $ (middle soft key).
2 Select Y, then press ,.
3 Select “Ringer Setup”, then press
,
.
4 Select “Night Mode”, then press
,
.
5 Select “Start/End”, then press ,.
6 Enter the desired hour and minute you
wish to start this feature by selecting 2
digits for each.
L
If you use 12-hour time entry, select
“AM” or “PM” by pressing {*}
repeatedly before entering the time.
7 Enter the desired hour and minute you
wish to end this feature by selecting 2
digits for each.
L
If you use 12-hour time entry, select
“AM” or “PM” by pressing {*}
repeatedly before entering the time.
8 Press ,.
9 Press {ih}.
Turning night mode on/off
1 Press $ (middle soft key).
2 Select Y, then press ,.
3 Select “Ringer Setup”, then press
,
.
4 Select “Night Mode”, then press
,
.
5 Select “On/Off”, then press ,.
6 Select “On” or “Off”, then press ,.
7 Press {ih}.
Note:
L
When the night mode is turned on, f is
displayed.
Setting the ring delay for night mode
This setting allows the handset to ring during
night mode if the caller waits long enough.
After the selected amount of time passes,
the handset will ring, useful when someone
urgently needs to speak with you. If you
select “No Ringing”, the handset will not
ring during night mode.
1 Press $ (middle soft key).
2 Select Y, then press ,.
3 Select “Ringer Setup”, then press
,
.
4 Select “Night Mode”, then press
,
.
5 Select “Ring Delay”, then press
,
.
6 Select the desired setting, then press
,
.
7 Press {ih}.
TG1850NZ(e).book Page 21 Monday, December 27, 2004 3:22 PM