Panasonic KX-TG1850NZ - Manual (Page 34)

Multi-unit Operation
34
L
If all registered handsets start ringing,
press {x} to stop, then repeat this
step.
L After pressing {x}, the rest of this
procedure must be completed within 1
minute.
6 Wait until “Enter Base PIN” is
displayed, then enter “0000” (default
base unit PIN), then press ,.
L
If you changed the PIN, enter it (page
28).
L When the handset has been
registered successfully, w will stop
flashing. If keytones are turned on
(page 24), a confirmation tone will be
heard.
Selecting a base unit
When “Auto” is selected, the handset will
automatically use any available base unit it
is registered to. When a specific base unit is
selected, the handset will make and receive
calls using that base unit only. If the handset
is out of range of that base unit, no calls can
be made.
1 Press $ (middle soft key).
2 Select Y, then press ,.
3 Select “Select Base”, then press
,
.
4 Select the desired base unit number, or
“Auto”, then press ,.
L
The handset starts searching for the
base unit.
Cancelling a handset
A maximum of 6 handsets can be registered
to a base unit. A handset can cancel its own
registration (or the registration of another
handset) that is stored in the base unit. This
will allow the base unit to “forget” the
handset.
1 Press $ (middle soft key).
2 Select Z, then press ,.
3 Enter “0000” (default base unit PIN).
L
If you changed the PIN, enter it (page
28).
4 Enter “335”.
5 Select “Cancel Handset”, then press
,
.
L The numbers of all handsets
registered to the base unit are
displayed.
6 Select the handset(s) you want to
cancel, by pressing the desired handset
number.
L
The selected handset number(s) will
flash.
L
To cancel a selected handset number,
press the number again. The number
will stop flashing.
7 Press ,.
8 Select “Yes”, then press ,.
9 Press {ih}.
Cancelling a base unit
A handset can be registered to a maximum
of 4 base units. A handset can cancel a base
unit that it is registered to. This allows the
handset to “forget” the base unit.
1 Press $ (middle soft key).
2 Select Y, then press ,.
3 Select “Registration”, then press
,
.
4 Enter “335”.
5 Select “Cancel Base”, then press
,
.
6 Enter “0000” (default handset PIN).
L
If you changed the PIN, enter it (page
23).
7 Select the base unit(s) you want to
cancel, by pressing the desired base unit
number.
L
The selected base unit number(s) will
flash.
TG1850NZ(e).book Page 34 Monday, December 27, 2004 3:22 PM