Panasonic KX-TG1850NZ - Manual (Page 42)

Useful Information
42
While storing an entry in the
phonebook or assigning a one
touch dial, the handset starts to
ring.
L
A call is being received. To answer the call, press
{C}
. Programming will be cancelled. Start again.
Pressing q does not
display/dial the last number dialled. L The redialled number was more than 24 digits long.
Redial the number manually.
The handset beeps intermittently
and/or 3 flashes.
L
Fully charge the batteries (page 10).
I fully charged the batteries, but
3
still flashes.
L Clean the charge contact and charge again (page
10).
L
It is time to replace the batteries (page 11).
Caller information is not displayed. L You must subscribe to Caller ID service.
L
Your unit is connected to a telephone line with
ADSL (JetStream) service. We recommend that
you contact your ADSL service provider to have an
ADSL Splitter installed. We do not recommend the
use of generic ADSL filters.
While viewing caller information,
the display returns to standby
mode.
L
Do not pause for over 1 minute while searching.
I cannot register a handset to a
base unit.
L
The maximum number of base units (4) are already
registered to the handset. Cancel unused base unit
registrations from the handset (page 34).
L
The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 34).
L You entered the wrong PIN number. If you forget
your PIN, consult your nearest Panasonic service
centre.
L
Locate the handset and the base unit away from
other electrical appliances.
Problem Cause & solution
TG1850NZ(e).book Page 42 Monday, December 27, 2004 3:22 PM