Panasonic KX-TG2388 - Manual (Page 36)

Programmable Settings
36 For assistance, please visit http://www.panasonic.com/consumersupport
Programming via direct commands
You can also program features using “direct commands”—special codes that take you
directly to the feature you wish to program and allow you to select the desired setting.
There is no need to scroll through the unit’s menus.
Details of each feature can be found on the corresponding pages.
Important:
L Before programming, make sure the handset and base unit are not being used. The
handset must be operated near the base unit and while off the base unit or charger.
1
Press {MENU}.
2
Enter the desired feature code (page 37).
3
Enter the desired setting code (page 37).
L
This step may vary depending on the feature being programmed.
4
Press {Save}.
5
Press {OFF} to exit programming mode.
Note:
L If you make a mistake or enter the wrong code, press {OFF} then start again by
pressing {MENU}.
Initial setting Set answering Number of rings
54
Recording time
54
Remote code
54
Recording mode
55
Message alert
— 55
LCD contrast
— 41
Key tone
— 42
Auto talk
— 43
Caller ID edit
— 42
Set tel line Set dial mode
15
Set flash time
43
Set line mode
43
Set base unit Ringer tone
40
Incoming call.
40
Talk Caller ID
41
Change language
— 14
Main menu Sub-menu 1 Sub-menu 2 Page