Panasonic CF-R1 User Manual
Page 26
26
If the card is set for [Use when logging on to Windows]
SD Memory Card/MultiMedia Card
If you are prompted to enter your password during Windows logon…
<If [Leave set] was selected in step
4
for “Initialization (SD Card Setup)”>
Insert the SD memory card.
(If the card has already been inserted, reinsert it.)
<If [Set and eject] was selected in step
4
for “Initialization (SD Card Setup)”>
Insert the SD memory card, then eject it.
If you are prompted to enter your password when you try to use the computer in standby or hibernation mode …
<If [Leave set] was selected in step
4
for “Initialization (SD Card Setup)”>
Insert the SD memory card.
(If the card has already been inserted, reinsert it.)
<If [Set and eject] was selected in step
4
for “Initialization (SD Card Setup)”>
Insert the SD memory card, then eject it.
If you are prompted to enter your password when you try to use the computer while the screensaver is active…
<If [Leave set] was selected in step
4
for “Initialization (SD Card Setup)”>
Insert the SD memory card.
(If the card has already been inserted, do not reinsert it.)
<If [Set and eject] was selected in step
4
for “Initialization (SD Card Setup)”>
Insert the SD memory card, then eject it.
You can also enter your password to log on to Windows or resume from standby or hibernation mode
when the computer is in standby or hibernation mode, or when the screensaver is active.
If you select [Leave set] in step
4
for “Initialization (SD Card Setup)” and a registered SD memory card
is already inserted, the Windows logon screen does not appear when the computer is started.
NOTE
CAUTION
If the card is set for [Use when logging on to Windows]
When you are logging on to Windows or trying to resume computer while the screensaver is active, if the SD
memory card indicator is blinking, enter the password through the keyboard without removing the SD memory
card.
A software application, etc. may be accessing the SD memory card.
We recommend removing the SD memory card in the following cases:
After logging off
Before the computer enters either the standby or hibernation mode
If there is a possibility that the screensaver will be activated
If you use an SD memory card with incorrect settings
When the computer is being started, an icon appears for approximately three seconds, after which the
computer will turn off.
You cannot log on to Windows.
You cannot resume computer from standby or hibernation mode.
You cannot disable the screensaver.
Reinsert an SD memory card with correct settings, or enter the appropriate password.
If you select [Set and eject], insert the SD memory card, then eject if after you hear a beep indicating card
recognition.
If the computer does not respond properly when you insert the SD memory card, remove the card and wait
a few seconds, then reinsert it.
Do not remove or insert the SD memory card until Windows has completed loading.