Panasonic AW-RP400E - Manual (Page 19)

Indoor Pan/Tilt Head AW-PH400
18 (E)
ENGLISH
Specifications
Genlock input: BNC
Black burst or composite video signal
Prompter input
(PROMPTER IN): BNC
Through output to PROMPTER connector
Prompter output
(PROMPTER OUT): D-SUB 15-pin
Camera video output
VIDEO: BNC, 75-ohm output, 1 Vp-p
Connecting cable: 5C-2V, max. 1000 meters
Y, Pr/C, Pb: Y/C
Y: 1 Vp-p/75 ohms
C: 0.285Vp-p/75 ohms (burst)
Component video:
Y: 1 Vp-p/75 ohms
Pr: 0.7Vp-p/75 ohms
Pb: 0.7Vp-p/75 ohms
Connecting cable: 5C-2V, max. 1000 meters
SDI: BNC
Camera, pan/tilt head control: RJ45, RS-485, pan/tilt head control signal output
RP/IP Connecting cable: 10BASE-T straight cable (equivalent to UTP category 5),
max. 500 meters
Functions/performance: Maximum load-bearing capacity: 8 kg
Tilt range: 190 degrees (approx. ±95 degrees)
The tilt range is subject to restrictions depending on the cable and lens of camera to be
mounted on pan/tilt head.
Pan range: 400 degrees (approx. ±200 degrees)
Maximum operating speed: 90 degrees/sec.
(Maximum operating speed with prompter mounted: 30 degrees/sec.)
Repeatability: ±30”
Noise level: Less than NC30 (at less than 30 degrees/sec.)
Ambient operating temperature: 0°C to +45°C
Storage temperature:
–20°C to +60°C
Ambient operating humidity: 30% to 90% (no condensation)
Dimensions (W ! H ! D): ??? ! ??? ! ??? mm
Weight: Approx. ?? kg
Finish: AV ivory paint (colour resembling Munsell 7.9Y6.8/0.8)
Supply voltage: AC 240V, 50/60 Hz
Power consumption: 145W
1
indicates safety information.