Printek FieldPro RT43 - Manual (Page 10)

Getting Started
Figure 2 - Battery Installation
Release Lever
Battery Contacts
To charge the battery, connect an optional power supply to the appropriate input source, and then connect the
output of the power supply to the printer’s Power Connector at the location shown in Figure 3. The Battery
Indicator will turn on and remain on until the battery is fully charged. This may take up to 2½ hours.
Note: You must charge the battery for at least 2½ hours prior to the first use.
Caution: Use only Printek power supplies designed specifically for your FieldPro printer. Using a different
power supply may cause damage to the printer and will not be covered by the printer’s warranty.
Printek power supplies are available for use with 100-240VAC/50-60Hz and for12/24VDC vehicle
applications.
Power Connector
Battery Indicator
Figure 3 - Power Connector & Battery Indicator
4