Printek FieldPro RT43 - Manual (Page 21)

Printer Configuration
PRINT ALL LOGOS IN MEMORY
Modify From
Menu Item Values Default Value Control
Panel
Setup
Utility
Print All Logos in Memory n/a n/a 9 *
OPTIONS MENU
Modify From
Menu Item Values Default Value Control
Panel
Setup
Utility
Left Paper Guide Adjust A – G A 9 9
Right Paper Guide Adjust None, 1 – 9 None 9 9
Auto Power Down Off, 1 – 15 Minutes Off 9 9
Print Promo Off, On Off 9 9
Print Header Off, On Off 9 9
HARDWARE MENU
Modify From
Menu Item Values Default Value Control
Panel
Setup
Utility
Enter Hex Dump Mode Off, On Off 9
Burnin Mode Off, On Off 9
Reset to Factory Defaults Hold Power 10 Sec. n/a 9 9
Interface Menu
The Interface Menu is actually a series of menus. These menus are used to match the printer to the host system
or device that will be used to send and/or receive data to/from the printer. Which Interface Menu affects the
printer is dependent upon whether an optional Bluetooth or Wi-Fi interface is installed, and if so, which
interface is currently selected as the active interface. Switching the active interface from one interface to the
other is only available through Control Panel Setup and is described on page 25. The menu features for the
Serial, Bluetooth, and Wi-Fi interfaces are described below.
Note: When using Control Panel Setup, you may select “Print Interface Settings” to obtain all the features
and their values for the currently selected interface.
15