Installing the batteries (kx-f1100al only), Installing the batteries – Panasonic KX-F1000AL User Manual

Page 7

Advertising
background image

7

1. Installation and Connection

Installing the batteries

(KX-F1100AL only)

1

The batteries are required to retain greeting and incoming voice messages in memory when the power cord is
disconnected or during a power failure. Install four AA batteries (supplied) before using the unit.

1

Open the top cover, then open the front lid by
sliding the lever towards you.

2

Remove the battery compartment cover by
pulling the hook towards you and lifting it up.

3

Install four batteries into the compartment
using correct polarity (+, –).

4

Replace the battery compartment cover by;

A

Insert the tab of the cover into the hole.

B

Press down the area marked “PRESS”
until it clicks into place.

5

Close the front lid securely by pushing down
on both sides, then close the top cover.

PRESS

Note:

¡

Message retention time during a power failure is approximately 1 day with new batteries.

¡

Install new batteries when the display shows “BATTERY LOW”.

¡

To avoid losing the greeting and all messages saved in memory, the power cord must remain connected
when replacing batteries.

¡

Disconnect the telephone line cord before opening the battery compartment cover.

¡

Replace all the batteries once a year, or mis-operation may occur.

¡

For further information about batteries, see page 81.

A

B

PRESS

Front lid
open lever

Front lid

Top cover

Advertising
This manual is related to the following products: