Panasonic BL-C30 - Manual (Page 20)

Installation/Troubleshooting
20
Troubleshooting
Indicator
continues
blinking green. • Automatic setup is not complete.
Complete the setup following Getting Started.
• The camera did not get its IP address from the DHCP server.
When setting [Automatic Setup] or [DHCP Setup], the
camera may not get its IP address due to network failures.
Ask your ISP or network administrator for more information.
Indicator does
not light up. • Indicator display is disabled.
Check if the indicator control is disabled (see page 80 of the
Operating Instructions on the Setup CD-ROM).
• Confirm that the standard AC adaptor PQLV202 (Order No.
PQLV202X) is being used.
Indicator
continues
blinking red. • The camera may be malfunctioning.
If you cannot access the camera, the camera may be
malfunctioning. Call our customer call center.
Indicator lights
red. • The camera is in privacy mode.
To disable the privacy mode, press the privacy button (see
page 8) on the front of the camera or click [Disable]
accessing and logging in to the camera as an administrator.
Indicator
continues
blinking orange
during the
wireless
communication. • Only the MAC addresses for the camera's wireless module are
set.
To enable the MAC address filtering feature on the wireless
router, enter both the MAC addresses for the camera itself
and the camera's wireless module.
Problem Cause and Remedy