Panasonic BL-C30 - Manual (Page 28)

Installation/Troubleshooting
28
Troubleshooting
Image is out of
focus. • The lens has dust, dirt, fingerprints or droplets on it.
Clean the lens with a cotton bud (see page 102 of the
Operating Instructions on the Setup CD-ROM).
• The object is too close to the camera.
The camera cannot focus at short distances
(less than 0.5 m). Locate the object more than 0.5 m away
from the camera.
The color on the
image is
strange. • White balance does not work well.
Adjust the white balance on the Camera page (see page 45
of the Operating Instructions on the Setup CD-ROM).
• The color display setting on your PC is set lower than 16 bits.
Set the color display 16 bits or higher.
Image flickers. • The object is dark.
Make the area around the camera brighter.
• The AC power source frequency setting is wrong.
Set the proper AC power source frequency used in your area
(see page 45 of the Operating Instructions on the Setup CD-
ROM).
• A bright object may cause horizontal flickers on the image.
Changing the object improves the flickers. Or adjusting
brightness to the [+] side on the operation bar eases the
flickers.
An old image is
displayed. • The old image is temporarily stored on the web browser.
Set [Every visit to the page] on the web browser to check for
temporary Internet files (see page 110 of the Operating
Instructions on the Setup CD-ROM).
Problem Cause and Remedy